Skip to main content

HG 1/144 O GUNDAM A.C.D (Active Colour Design)

Image
By
Hello everyone....
For today's post, i will show you one of my hobbies....yeah! GUNDAM
Well, i already finished to build my O Gundam A.C.D kit and also to review it. I really like this kit, do a lot panel lining on it too. Overall, this kit is really great, look simple in design but really have good articulation and detail for HG kit.
Good work, Bandai.
Hope all of you enjoy these pics



Coloring, really not to do a lot of thing...at least you just can do some panel lining  







Bandai has getting better on articulation on HG model, with no exception on O Gundam. Despite on simple design (RX-78 design), you just can make hand, body, leg rotate all over, even can move the hand over back to grab the saber 
Also, good design on shield holder, with handle like that, slip on the hand and not to make any hole the Gundam's arm

What a pose....like a final pose on final stage versus Exia Repair.
(hmmm....O Gundam ready to kick his ass, despite the fact that his ass kicked in the end  )


That's all for the review. See you next for the other review Gundam kit

Labels

Labels:

Comments

  1. UnknownApril 6, 2011 at 2:02 PM

    Nice review bro..congrats on your first blog..
    me too, personally the 144 HG scale of the 00 Gundam series is far superior than its 1/100 No Grade counterpart, that is why i like the 144 scale far better...hehehehehe

    anyways congrats on your blog, keep it up

    ReplyDelete

Post a Comment

Popular posts from this blog

Satellite Communication - Part 4 (CPI)

By
Cross Polar Isolation (CPI) In installation and pointing/peaking antenna, Orthogonal Mode Transducer (OMT) must be set to be as precise as possible to get the best CPI value. above is picture of OMT Feed assembly include with BUC and LNB The minimum value for CPI is 30 dB (better will be good) in Linier Polarized Antennas. The reason is for our receive (Rx)-side as not to get interferenced (distrubed) by other (polarity) Down-Link users, therefore our transmit (Tx) shoild as well not interfere other users that operates at 90 deg (Orthogonal) Polarization. Note : In LH/RH Circular Polarizations, usually CPI of 27dB (=AR of 1.09) is acceptable enough. picture above is careless/miss-aligned OMT setting
Post a Comment
Read more

Satellite Communication : Transmission Bands

By
A satellite link is a radio link between a transmitting earth station and receiving earth station through a communications satellite. A satellite link consists of one uplink and one downlink; the satellite electronics (i.e., the transponder) will remap the uplink  frequency to the downlink frequency. The transmission channel of a satellite system is a radio channel using a direct-wave approach, operating in at specific RF bands within the overall electromagnetic spectrum as seen below : The table below shown some key of physical parameters of relevance to satellite communication,  The frequency of operation is in the super high frequency (SHF) range (3-30 GHz). Regulation and practice dictate the frequency of operation, the channel bandwidth, and the bandwidth of the subchannels within the larger channel. Different frequencies are used for the uplink and for the downlink. Frequencies above about 30 MHz can pass through the ionos...
Post a Comment
Read more

High Throughput Satellite Service - more than modems and transmission

By
The advent of High Throughput Satellite (HTS) has been significant amount of new satellite capacity come online in recent years, prompting industry-wide disruptive innovation. This lower cost capacity enables a new era of satellite communications, with innovative new applications spreading around the world. However, there are a number of factors that must be considered for the operation of a successful HTS service. The satellite industry is undergoing a dramatic evolution as more and more High Throughput Satellite (HTS) capacity is introduced to markets around the world, like Intelsat Epic , Inmarsat Global Express , Viasat-2 , SES-12 ,etc. HTS is bringing more and lower-cost capacity that enables the satellite industry to cost-effectively provide large-scale internet services to rural and other hard-to-serve areas around the world. To enable these services, many providers are focusing on selecting the optimal ground system, and rightly so, because the ground system is a key e...
Post a Comment
Read more